HowTune

1990 Plymouth Laser Recalls

  1. Recall Description

    THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

    Possible Effects

    THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

    Action

    OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

    Notes

    SYSTEM: INTERIOR; SEAT BELTS; BELT BUCKLES.VEHICLE DESCRIPTION: PASSENGER, MULTI-PURPOSE VEHICLES AND LIGHT DUTY TRUCKS EQUIPPED WITH SAFETY BELTS MADE BY TAKATA CORPORATION.NOTE: IF YOUR VEHICLE IS PRESENTED TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND THE REMEDY IS NOT PROVIDED FREE OF CHARGE WITHIN A REASONABLE TIME, PLEASE CONTACT CHRYSLER AT 1-800-853-1403. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S AUTO SAFETY HOTLINE AT 1-800-424-9393.

    Recall Manufacture Dates

    1986-01-01 - 1991-12-01

    Vehicles Affected

    920000
  2. Recall Description

    WIRING HARNESS FOR THE HEADLAMPS MAY BREAK DUE TO THE STRESS CREATED BY THE HEADLAMP POP UP DEVICES.

    Possible Effects

    BREAKAGE OF THE WIRING HARNESS CAUSES LOSS OFHEADLAMP ILLUMINATION WHICH COULD HAVE A POTENTIAL FOR AN ACCIDENT.

    Action

    HEADLAMP WIRING HARNESS ROUTING WILL BE MODIFIED AND DAMAGED WIRES REPAIRED.

    Notes

    SYSTEM:ELECTRICAL, UNDERHOOD WIRING HARNESS.VEHICLE DESCRIPTION:PASSENGER CARS.

    Recall Manufacture Dates

    1988-09-01 - 1989-04-01

    Vehicles Affected

    5510
  3. Recall Description

    DILUTED PRIMER MAY HAVE BEEN USED ON THE WINDSHIELD OPENING FLANGES PRIOR TO WINDSHIELD GLASS INSTALLATION WHICH WOULD NOT PROVIDE THE RETENTION REQUIRED BY FMVSS 212.

    Possible Effects

    WINDSHIELDS WOULD NOT PREVENT EJECTION OF VEHICLEOCCUPANTS DURING A VEHICLE CRASH, WHICH CAUSES SERIOUS INJURIES AND FATALITIES.

    Action

    REPLACE WINDSHIELDS, ASSOCIATED PARTS, AND PRIMER.

    Notes

    SYSTE: WINDSHIELD MOUNTING; FMVSS 212.VEHICLE DESCRIPTION: PASSENGER CARS.

    Recall Manufacture Dates

    1990-05-01 - 1990-05-01

    Vehicles Affected

    184
  4. Recall Description

    OPERATION OF SUNROOF IN "NON-STANDARD" MANNER MAY CAUSE MALE HINGE DISENGAGEMENT FROM THE ROOF HINGE RECEIVER.

    Possible Effects

    THE SUNROOF GLASS COULD DETACH FROM THE ROOF AND RESULTIN INJURY TO OCCUPANTS OR PERSONS IN THE VICINITY, ESPECIALLY IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION.

    Action

    REPLACE MALE HINGE WITH A MODIFIED VERSION TO INCREASE ROOF HINGE RECEIVER RETENTION ABILITY.

    Notes

    NOTE: THIS RECALL APPLIES ONLY TO DIAMOND STAR MOTORS INSTALLED SUNROOFS.CHRYSLER CORPORATION''S PLYMOUTH AND EAGLE DEALERSHIPS AND MITSUBISHI MOTOR SALESOF AMERICA WILL IMPLEMENT THE RECALL ACTION.SYSTEM: SUNROOF HINGES.VEHICLE DESCRIPTION: PASSENGER CARS EQUIPPED WITH DSM MANUFACTURED SUNROOFS.

    Recall Manufacture Dates

    1989-06-01 - 1989-12-01

    Vehicles Affected

    265