First open the hood.

Find this support that holds the crash beam. There are 3 screws on one side and 1 on the other, focus on the single screw. Remove this bolt. If you can't because it's too tight, you can use a separate hex nut and just screw it on top of the original bolt.

Now onto the bracket. You will use the upper hole of the bracket. Hold the bracket like shown in the picture to get a better idea of which way up is.

If you feel you need more space, install the bracket from underneath the car. The photo is a view from the under carriage. after we inserted the mounting bracket, use the additional hex nut and hand secure to the screw to make installing the LED light bar simpler. Do the same on the other side.

Bolt on the LED light bar onto the mounting brackets. Take the washer and thread it around the screw. Then screw in the LED light bar onto both of the mounting brackets. You might notice that the after attaching the LED light bar onto the brackets that the assembly is not exactly perpendicular. This small tilt is completely normal, but you can slightly adjust the angling of the brackets with your hand to fit the LED light bar perfectly in the center of the lower bumper opening. When the LED light bar is positioned to your taste, then you can fully tighten all of the bolts from the previous steps.

Wire up the LED Light Bar