HowTune

Refill The Coolant on a Honda S2000

This article is visible to only you.

Making sure that your S2000 has the proper amount of coolant is important to keeping it from overheating. The good news is that this maintenance is very easy to do.

  • Antifreeze Coolant (Preferably a pre-diluted 50/50 mix)
  • A funnel
  • Paper towels

Finding the radiator overflow reservoir

1

Open the hood and locate the reservoir - it'll be the plastic tank near the front of the car on the driver's side. You'll see the hose from the radiator connected to the reservoir tank.

2

Note the Max and Min fill lines on the tank.

Checking coolant levels

3

Unscrew the cap and peek inside to determine where the fluid level is at. If the fluid isn't near the Max line then you'll want to top it off.

Adding new coolant

4

Pull the cap and hose out of the tank and put your funnel inside the tank opening. It would be a good idea to rest the hose on a paper towel so you don't dirty your engine bay.

5

(If you don't have a pre-diluted mix you'll need to make a mixture of 50% antifreeze to 50% water.)

6

Slowly add coolant, making sure not to exceed the Max line.

Image 1067 from Refill the Coolant on a Honda S2000

Wrap up

7

Remove your funnel and put the cap back on the overflow tank. You're now good to go!

  • At full capacity the tank takes approximately 6.5 liters (6.5L)
  • The OEM tank is Honda part #19101-PCX-000

There are 0 Comments.

Say Something.

Post Your Comment

Post Your Comment

Cancel

You have to log in to comment...

Register or

We'll publish your comment after you're logged in.