1991 Volkswagen Jetta Recalls

1. Recall Description

   AN ENGINE PREHEATING TUBE MAY NOT BE PROPERLY SUPPORTED DUE TO A MISSING SUPPORT BRACKET, CAUSING THE PREHEATING TUBE TO CHAFE AGAINST THE RIGHT FRONT METAL BRAKE LINE. THIS CAN DAMAGE THE HYDRAULIC LINE, CAUSING BRAKE FLUID LEAKAGE AND DIMINISHED BRAKING IN ONE BRAKE CIRCUIT.

   Possible Effects

   DIMINISHED BRAKING CAN RESULT IN INCREASED STOPPINGDISTANCES AND A POSSIBLE ACCIDENT.

   Action

   DEALERS WILL INSTALL A PREHEATING TUBE SUPPORT BRACKET TO ENSURE PROPER POSITIONING RELATIVE TO THE RIGHT FRONT METAL BRAKE LINE.

   Notes

   SYSTEM: BRAKES; HYDRAULIC LINES.VEHICLE DESCRIPTION: PASSENGER CARS EQUIPPED WITH DIGIFANT ENGINE MANAGEMENTSYSTEMS.

   Recall Manufacture Dates

   1987-08-01 - 1991-07-01

   Vehicles Affected

   76000

2. Recall Description

   THE LOCK NUT OF THE CRUISE CONTROL ROD FOR THE OPERATING SERVO MAY NOT HAVE BEEN PROPERLY TORQUED DURING MANUFACTURE.

   Possible Effects

   INADEQUATE TORQUE OF THE LOCK NUT COULD ALLOW THE RODADJUSTMENT TO CHANGE. THIS COULD INCREASE THE ENGINE IDLE SPEED, AND POSSIBLYINCREASE STOPPING DISTANCE WITH A POTENTIAL FOR A VEHICLE ACCIDENT.

   Action

   CHECK AND ASSURE PROPER LOCK NUT TORQUE ON THE CRUISE CONTROL ROD.

   Notes

   SYSTEM: CRUISE CONTROL.VEHICLE DESCRIPTION: PASSENGER CARS; CALIFORNIA MODELS EQUIPPED WITH CRUISECONTROL.

   Recall Manufacture Dates

   1990-10-01 - 1991-03-01

   Vehicles Affected

   550

3. Recall Description

   THE VENTURI TUBE LOCATED IN THE THROTTLE VALVE HOUSING CAN BECOME LOOSE AND FALL AGAINST THE THROTTLE PLATE.

   Possible Effects

   THE VENTURI TUBE CAN PARTIALLY BLOCK THE THROTTLE PLATEAND PREVENT IT FROM RETURNING TO ITS FULL IDLE POSITION, RESULTING IN UNWANTEDENGINE SPEED WHEN THE VEHICLE IS PLACED IN A FORWARD OR REVERSE GEAR.

   Action

   REPLACE THE PRESS-FIT VENTURI TUBE WITH A THREAD TYPE TUBE.

   Notes

   SYSTEM: FUEL: THROTTLE VALVE HOUSING.VEHICLE DESCRIPTION: PASSENGER CARS WITH 16 VALVE ENGINES AND CALIFORNIAEMISSION CONTROL SYSTEMS.

   Recall Manufacture Dates

   1989-10-01 - 1992-06-01

   Vehicles Affected

   12650

4. Recall Description

   THE FUEL HOSE ATTACHED TO THE FUEL DISTRIBUTION RAIL ON THE ENGINE MAY SHRINK BEYOND THE CLAMP FORCE OF THE FUEL HOSE CLAMPS, ALLOWING FUEL TO LEAK.

   Possible Effects

   FUEL LEAKAGE IN THE ENGINE COMPARTMENT CAN CAUSE AN UNDERHOOD FIRE IF THE FUEL COMES IN CONTACT WITH A SOURCE OF IGNITION.

   Action

   REPLACE THE FUEL HOSE ATTACHED TO THE FUEL RAIL AND INSTALL A NEW SPRING TYPE SELF-TIGHTENING CLAMP.

   Notes

   SYSTEM: FUEL LINES.VEHICLE DESCRIPTION:PASSENGER CARS.

   Recall Manufacture Dates

   1985-07-01 - 1992-06-01

   Vehicles Affected

   358000

5. Recall Description

   FRONT BRAKE HOSES OF INSUFFICIENT LENGTH WERE INSTALLED IN SOME VEHICLES. THESE SHORT HOSES COULD STRETCH AND DEVELOP CRACKS.

   Possible Effects

   THIS COULD RESULT IN BRAKE FLUID LEAKAGE, WITH LOSS OFFLUID PRESSURE AND BRAKING ABILITY.

   Action

   REPLACE BOTH BRAKE HOSES.

   Notes

   SYSTEM: FRONT BRAKE HOSES.VEHICLE DESCRIPTION: PASSENGER CARS.

   Recall Manufacture Dates

   1990-05-01 - 1990-06-01

   Vehicles Affected

   465

6. Recall Description

   CERTAIN HYDRAULIC BRAKE HOSES, P/N 171.611.107B, SOLD AS REPLACEMENT EQUIPMENT FOR 1975-1985 VOLKSWAGEN (VW) RABBIT; 1985-1992 VW GOLF; AND 1980-1992 VW JETTA PASSENGER VEHICLES. POSSIBLE BRAKE HOSE RUPTURE COULD OCCUR WHICH FAILS TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 106, "BRAKE HOSES."

   Possible Effects

   BRAKE HOSE RUPTURE COULD RESULT IN LOSS OF BRAKING ABILITY, POSSIBLY RESULTING IN A VEHICLE CRASH.

   Action

   FOREIGN PARTS DISTRIBUTORS WILL NOTIFY OWNERS AND REPLACE THE BRAKE HOSES WITH COMPLIANT BRAKE HOSES. THE RECALL BEGAN ON MARCH 30, 2006. OWNERS MAY CONTACT FOREIGN PARTS DISTRIBUTORS AT 305-885-8646 EXT. 11.

   Notes

   CUSTOMERS MAY CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY: 1-800-424-9153); OR GO TO HTTP://WWW.SAFERCAR.GOV.

   Recall Manufacture Dates

   -

   Vehicles Affected

   266

7. Recall Description

   SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

   Possible Effects

   DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

   Action

   SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

   Notes

   THIS RECALL ONLY PERTAINS TO AFTERMARKET REPLACEMENT EQUIPMENT AND HAS NO RELATION TO ANY ORIGINAL EQUIPMENT INSTALLED ON VEHICLES PRODUCED BY THE VEHICLE MANUFACTURER.IN ORDER TO DETERMINE IF YOUR AFTERMARKET LAMP ASSEMBLY IS AFFECTED BY THIS NONCOMPLIANCE, PLEASE REVIEW THE LIST OF MODEL NUMBERS PROVIDED TO US BY SABERSPORT.THE LIST CAN BE FOUND UNDER "DOCUMENT SEARCH" LOCATED AT THE BOTTOM OF YOUR SCREEN.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION''S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO <A HREF=HTTP://WWW.SAFERCAR.GOV>HTTP://WWW.SAFERCAR.GOV</A> .

   Recall Manufacture Dates

   -

   Vehicles Affected

   16270