Replace The Rear Turn Signal Bulbs on a Scion FR-S

This article is visible to only you.

At some point, you're going to have to replace all of the bulbs in your car. Fortunately, the turn signal bulbs are relatively easy to replace on the Scion FR-S.

Estimated time: 5 minutes


Put the car in accessory mode by turning the key as much as you can without starting the car.


Turn on the hazard lights by pressing the red triangle button next to the clock.


Check the back of the car. If one of the turn signals isn't blinking, you need to replace that bulb.


Using a Phillips head screwdriver or a prying tool, remove the pop fastener closest to the trunk lid.


Gently pry the carpet away to gain access to the tail light fixture.

Image 2969 from Replace the Rear Turn Signal Bulbs on a Scion FR-S

Rotate the socket counter-clockwise and pull it out of the fixture.

Image 2972 from Replace the Rear Turn Signal Bulbs on a Scion FR-S

Pull the bulb straight out of the socket and replace it with a new one.


Insert the socket back into the fixture and turn clockwise to lock it back into place.


Use the testing procedure in the Symptoms section above to test the bulb.


Tuck the carpet back under the weather stripping and replace the pop fastener.

There are 0 Comments.

Say Something.

Post Your Comment

Post Your Comment


You have to log in to comment...

Register or

We'll publish your comment after you're logged in.