1983 Ford F250 Recalls

1. Recall Description

   WATER SEPARATOR CANISTER MAY BE PUNCTURED IN A COLLISION. CRASH TESTS IN A 30 MPH FRONTAL COLLISION REVEALED FUEL LEAKAGE EXCEEDING THE MAXIMUM PERMITTED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".

   Possible Effects

   Action

   A PROTECTIVE SHIELD FOR THE CANISTER WILL BE INSTALLED WITHOUT CHARGE.

   Notes

   VEHICLE DESCRIPTION: TRUCKS; 4X4 CHASSIS CABS EQUIPPED WITH 6.9 LITER DIESELENGINES. VEHICLES EQUIPPED WITH A PICKUP BOX THAT WAS REMOVED AFTER DELIVERY(TO INSTALL OTHER AFTERMARKET BODIES).SYSTEM: FUEL SYSTEM: FUEL WATER SEPARATOR CANISTER.CONSEQUENCES OF DEFECT: IF THE FUEL WATER SEPARATOR CANISTER IS PUNCTURED, FUELLEAKAGE COULD CAUSE A FIRE RESULTING IN PERSONAL INJURY TO VEHICLE OCCUPANTS.

   Recall Manufacture Dates

   1982-08-01 - 1984-04-01

   Vehicles Affected

   36400

2. Recall Description

   THE SPRINGS THAT ASSIST IN RAISING THE HOOD MAY DETACH FROM THE HOOD WITHOUT WARNING. THE HOOD CAN BE IN ANY POSITION WHEN THIS OCCURS.

   Possible Effects

   Action

   THE DEALER WILL REPLACE THE HOOD LIFT ASSIST SPRING ASSEMBLIES WITH REVISED PARTS.

   Notes

   VEHICLE DESCRIPTION: LIGHT TRUCKS OVER 8,500 GVWR EQUIPPED WITH 6.9 LITERDIESEL ENGINES.SYSTEM: HOOD ASSEMBLY; HINGE ATTACHMENTS.CONSEQUENCES OF DEFECT: SPRING DETACHMENT MAY CAUSE THE SPRING TO STRIKEPERSONS NEARBY. IT IS ALSO POSSIBLE FOR THE HOOD TO FALL UNEXPECTEDLY CAUSINGPERSONAL INJURY.NOTE: THE OWNER IS ADVISED TO AVOID OPENING AND CLOSING THE HOOD UNTIL THEVEHICLE CAN BE REPAIRED.

   Recall Manufacture Dates

   1982-08-01 - 1982-10-01

   Vehicles Affected

   600

3. Recall Description

   IN A COLLISION, BOLTS MAY DAMAGE OR PIERCE A FUEL LINE, CAUSING FUEL SPILLAGE. AFFECTED VEHICLES MAY NOT BE CAPABLE OF MEETING THE MINIMUM FUEL LEAKAGE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY".

   Possible Effects

   Action

   THE DEALER WILL REPLACE THE EXISTING 2.18 INCH BOLTS IN THE LEFT FRONT FENDER APRON WITH ONE INCH LONG BOLTS AT NO CHARGE.

   Notes

   VEHICLE DESCRIPTION: LIGHT TRUCKS EQUIPPED WITH 6.9 LITER DIESEL ENGINES.SYSTEM: STRUCTURE; FENDER APRON ATTACHING BOLTS.CONSEQUENCES OF DEFECT: EXCESSIVE LENGTH BOLTS HAVE THE POTENTIAL TO CONTACTAND DAMAGE THE FUEL LINE DURING VEHICLE IMPACTS. FUEL LEAKAGE IN THE PRESENCEOF A SOURCE OF IGNITION COULD RESULT IN A FIRE.

   Recall Manufacture Dates

   1983-01-01 - 1983-03-01

   Vehicles Affected

   1800

4. Recall Description

   ON CERTAIN VEHICLES, THE LOCK WEDGES USED TO SECURE THE AXLE BEARING NUTS TO THE AXLE HOUSING MAY FALL OUT OF POSITION, ALLOWING THE NUT TO LOOSEN. THE NUT ON THE LEFT SIDE MAY FALL OFF, ALLOWING MOVEMENT OF THE AXLE SHAFT.

   Possible Effects

   Action

   THE DEALER WILL REPLACE DEFECTIVE LOCK WEDGES WITH AN IMPROVED VERSION. WHEEL BEARINGS WILL BE INSPECTED AND ADJUSTED OR REPLACED, IF NECESSARY.

   Notes

   VEHICLE DESCRIPTION: LIGHT TRUCKS WITH DANA FULL-FLOATING REAR AXLES.SYSTEM: POWER TRAIN; REAR AXLE ASSEMBLY.CONSEQUENCES OF DEFECT: THIS COULD RESULT IN PARTIAL LOSS OF BRAKING ACTION ORPARTIAL OR TOTAL SEPARATION OF THE LEFT REAR WHEEL AND BRAKE ASSEMBLY. INEITHER CASE, LOSS OF VEHICLE CONTROL AND AN ACCIDENT COULD FOLLOW.

   Recall Manufacture Dates

   1981-10-01 - 1982-09-01

   Vehicles Affected

   74985

5. Recall Description

   SOME OF THE INVOLVED VEHICLES MAY HAVE A DIODE IN THE ELECTRICAL FUEL PUMP CIRCUIT THAT MAY SHORT DURING ENGINE STARTING DUE TO INADEQUATE CAPACITY TO WITHSTAND CURRENT DRAW. A SHORT CIRCUIT WOULD RESULT IN NORMAL ENGINE STARTING, BUT THE PUMP WILL NOT CONTINUE TO SUPPLY THE ENGINE WITH FUEL.

   Possible Effects

   Action

   THE DEALER WILL REPLACE DEFECTIVE ELEMENT IN THE ELECTRICAL FUEL PUMP CIRCUIT WITH A NEW RELAY FEED WIRING ASSEMBLY WHICH CONTAINS A LARGER CAPACITY DIODE, FREE OF CHARGE.

   Notes

   VEHICLE DESCRIPTION: LIGHT TRUCKS AND MULTIPURPOSE PASSENGER VEHICLES.SYSTEM: FUEL; FUEL PUMP.CONSEQUENCES OF DEFECT: UNDER SUCH CIRCUMSTANCES, A VEHICLE MAY STALL WITHOUTPRIOR WARNING, CREATING THE POTENTIAL FOR A VEHICLE ACCIDENT. (VEHICLE WILLRESTART BUT WILL STALL AGAIN IN 5 TO 10 SECONDS).

   Recall Manufacture Dates

   1982-09-01 - 1982-10-01

   Vehicles Affected

   650

6. Recall Description

   THE PARKING GEAR MAY NOT ENGAGE, EVEN THOUGH THE GEAR SHIFT LEVER IS PLACED IN THE "PARK" POSITION. THIS OCCURS IF THE LINKAGE INSIDE THE TRANSMISSION THAT ACTUATES THE PARK GEAR WAS IMPROPERLY MANUFACTURED. A PIN THAT RETAINS COMPONENTS ON A LINKAGE (ACTUATING) ROD COULD BREAK AND THE LINKAGE MAY NOT ENGAGE THE PARKING GEAR.

   Possible Effects

   Action

   DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE PARKING PAWL ACTUATING ROD ASSEMBLY.

   Notes

   VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC OVERDRIVETRANSMISSIONS.SYSTEM: POWER TRAIN; TRANSMISSION, PARKING PAWL ACTUATING ASSEMBLY.CONSEQUENCES OF DEFECT: IF THE PARKING BRAKE IS NOT APPLIED AND THE PARKINGGEAR DOES NOT ENGAGE, UNEXPECTED VEHICLE MOVEMENT COULD CAUSE AN ACCIDENT ANDPERSONAL INJURY.NOTE: DRIVERS SHOULD ALWAYS APPLY THE PARKING BRAKE WHENEVER LEAVING THEVEHICLE.

   Recall Manufacture Dates

   1982-12-01 - 1983-02-01

   Vehicles Affected

   98162