1975 Nissan 280z Recalls

1. Recall Description

   MOISTURE AND BLOW OF MIST PRESENT IN THE POSITIVE CRANKCASE VENTILATION SYSTEM MAY, UNDER CONDITIONS OF SUB-ZERO TEMPERATURES, ACCUMULATE IN THE AIR REGULATOR, CAUSING PROLONGED ENGINE IDLE, IF OWNER FAILS TO FULLY WARM ENGINE BEFORE DRIVING. THE PCV SYSTEM CAN ALSO CAUSE A GUMMING IN THE THROTTLE SHAFT WHICH WILL IMPAIR THE SMOOTH OPEN/CLOSE OPERATION OF THE THROTTLE.

   Possible Effects

   Action

   DEALER WILL INSPECT AND, IF NECESSARY, INSTALL A NEW PCV VALVE SYSTEM WITH INCREASED FLOW CAPACITY. THE THROTTLE CHAMBERS AND AIR REGULATORS WILL BE INSPECTED AND CORRECTED AND A FINAL SYSTEM INTEGRITY CHECK WILL BE PERFORMED AT NO COST TO OWNER.

   Notes

   VEHICLE DESCRIPTION: PASSENGER VEHICLES.SYSTEM: FUEL INJECTION; ELECTRICAL.CONSEQUENCES OF DEFECT: SHOULD HIGH IDLE OCCUR WHEN THE ROADS ARE WET ORCOVERED WITH SNOW AND ICE, HARD BRAKING CAN CAUSE LOSS OF VEHICLE CONTROL AND AVEHICLE ACCIDENT.NOTE: THE OWNER IS ADVISED TO WARM UP THE ENGINE PROPERLY BEFORE DRIVING THECAR IN SEVERELY COLD WEATHER.

   Recall Manufacture Dates

   1975-08-01 - 1978-10-01

   Vehicles Affected

   295710

2. Recall Description

   THERE IS A POSSIBILITY OF PREMATURE HOSE DETERIORATION DUE TO HIGH FUEL OXIDATION LEVELS WHICH WOULD ALLOW FUEL SEEPAGE AND FUMES TO ENTER THE VEHICLE.

   Possible Effects

   Action

   THE DEALER WILL INSPECT AND, IF NECESSARY, INSTALL A NEW HYPREX HOSE WITHOUT CHARGE TO OWNER.

   Notes

   VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH ELECTRONIC FUELINJECTION.SYSTEM: FUEL INJECTION; FUEL HOSE.CONSEQUENCES OF DEFECT: THIS CONDITION COULD LEAD TO A VEHICLE FIRE AND SERIOUSINJURIES TO PASSENGERS.

   Recall Manufacture Dates

   -

   Vehicles Affected

   389

3. Recall Description

   Possible Effects

   Action

   Notes

   DATSUN CAMPAIGN NO 76-0076.POSSIBILITY THAT THE METAL CLAMPS USED FOR THERUBBER HOSE IN FUEL SYSTEM IN THE ENGINE COMPARTMENT MAY TEND TO DEFORM WHENTIGHTENED DURING MAINTENANCE SERVICE AT DEALERS.IF THIS CONDITION EXISTS ITRESULTS IN A LOSS OF UNIFORM CLAMPING FORCE ON THE CIRCUMFERENCE OF THE HOSES.THIS CONDITION COULD CAUSE FUEL SEEPAGE IN THE ENGINE COMPARTMENT CREATINGGASOLINE FUMES AND POTENTIAL FIRE HAZARD.(CORRECT BY INSPECTING AND REPLACINGWITH AVIATION TYPE CLAMPS).

   Recall Manufacture Dates

   -

   Vehicles Affected

   31615