HowTune

1968 Volkswagen Type I Recalls

  1. Recall Description

    Possible Effects

    Action

    Notes

    POSSIBLE CRACKS IN THE GASOLINE TANK BREATHER TUBE, ESPECIALLY WHERE THE TUBE IS BENT.AS A RESULT, GASOLINE FUMES MAY ENTER THE VEHICLE INTERIOR.(INSPECT, CHECK, AND REPLACE BREATHER TUBE AS REQUIRED.)

    Recall Manufacture Dates

    -

    Vehicles Affected

    24438
  2. Recall Description

    Possible Effects

    Action

    Notes

    POSSIBILITY THAT THE ALLENHEAD BOLTS ON THE REAR AXLE UNIVERSAL JOINTS WERE NOT PROPERLY TORQUED AND WERE OCCASIONALLY INSTALLED WITHOUT SPRING WASHER.THIS CAN LEAD TO THE LOOSENING AND POSSIBLE LOSS OF BOLTS.(INSTALL SPRING WASHER AND RETORQUE BOLTS AS REQUIRED.)

    Recall Manufacture Dates

    -

    Vehicles Affected

    4368
  3. Recall Description

    Possible Effects

    Action

    Notes

    POSSIBILITY THAT THE GEARSHIFT LEVER STOP PLATE WAS NOT CORRECTLY POSITIONED.IF THIS PLATE IS NOT INSTALLED PROPERLY, THE REVERSE GEAR LOCKING DEVICE BECOMES INEFFECTIVE.DUE TO THIS, AN INADVERTENT SHIFT INTO REVERSE IS POSSIBLE.(REPOSITION AND ADJUST THE GEARSHIFT LEVER STOP PLATE AS REQUIRED.)

    Recall Manufacture Dates

    -

    Vehicles Affected

    5143
  4. Recall Description

    Possible Effects

    Action

    Notes

    FASTENING BOLT OF AN ACCESS HOLE COVER FOR GEARSHIFT ROD MAY PROTRUDE INTO THE SPARE TIRE COMPARTMENT AND RUB TIRE DAMAGING SIDE WALL.(CORRECT BY REPLACEMENT WITH A NEW TYPE COVER.)

    Recall Manufacture Dates

    1967-08-01 - 1967-08-01

    Vehicles Affected

    29022
  5. Recall Description

    Possible Effects

    Action

    Notes

    POSSIBILITY THAT THE RUBBER SEAL BETWEEN VENTILATION TUBE AND GAS TANK IS NOT PROPERLY SEATED.AS A RESULT, GASOLINE FUMES MAY ENTER THE VEHICLE INTERIOR.(INSPECT AND RESEAT RUBBER SEAL AS REQUIRED.)

    Recall Manufacture Dates

    -

    Vehicles Affected

    18042
  6. Recall Description

    Possible Effects

    Action

    Notes

    POSSIBILITY THAT THE HARNESS RUNNING BETWEEN THE CARBURETOR AND THE FAN HOUSING IS NOT PROPERLY AFFIXED BY THE SHEET METAL CLAMP TO THE FAN HOUSING.IN THIS CASE, IT IS POSSIBLE THAT THE WIRING IS HANGING DOWN.IN RESTING ON THE ACCELERATOR CABLE, THE INSULATION OF THE HARNESS AND WIRES CAN BE CHAFED THROUGH AND LEAD TO A SHORT CIRCUIT.(INSPECT, INSTALL CLAMP, AND REPLACE WIRING AS REQUIRED.)

    Recall Manufacture Dates

    -

    Vehicles Affected

    14022
  7. Recall Description

    Possible Effects

    Action

    Notes

    POSSIBILITY THAT FRONT SEAT OVER-THE- SHOULDER/LAP SAFETY BELTS HAVE TENDENCY TO GRADUALLY LOOSEN THEIR ADJUSTMENT.IF THIS OCCURS BELTS ARE NOT KEPT TAUT AND ARE NOT AS EFFECTIVE.(CORRECT BY INSPECTION AND ADD A SPRING DEVICE WHEN NECESSARY.)

    Recall Manufacture Dates

    - 1968-05-01

    Vehicles Affected

    293000